Anio Nimov
-
Posts
6 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Downloads
Blogs
Events
Posts posted by Anio Nimov
-
-
The issue was solved. CONFIG_NETLINK_DIAG was set to "y". A new firmware was compiled , modified via hex editor and loaded via TFTP.
Thank you.
-
Спасибо. Утилита ndmfw , которая добавляет подпись и TLV таблицу , не видна нигде в keenetic-sdk дереве.
Утилита zyimage прописьiвает перевернутое DEVICE_ID ( 0x00801711 вместо 0x11178000 ). Ето излечил.
Буду наступать грабли, ато шишек мало
-
Скачал keenetic-sdk с гитхаба. Собрал все строго по инструкции.
Получилось ето:
Где ткнуть палцем , подскажите
Когда делал впервье , все получолось. Машиньi разньiе - Ubunti 22, Debian 11 (x64).
-
Add Cloudflare NTP 162.159.200.1 and 162.159.200.123 by ip. They may change, but likely not frequently.
You can add nameserver by ip for a domain "ntp.org" - some of the following for example:
$$$dig +short c.ntpns.org A
89.40.214.141
212.12.50.229
45.11.105.142
46.227.203.69
50.116.32.247
$$$dig +short b.ntpns.org A
102.130.49.148
185.120.22.23
$$$dig +short a.ntpns.org A
185.209.85.151
45.79.130.187
185.134.197.79
185.209.84.218
185.126.112.98
212.25.19.23
-
I have a KN-1711. The firmware was updated to 3.9.8 ( 3.09.C.8.0-0 ) . EntWare was installed.
Ss command was installed via opkg . The command works ok, except message:
"Cannot open netlink socket: Protocol not supported" The kernel is 4.9-ndm-5 .
A kernel configuration parameter CONFIG_NETLINK_DIAG , responsible for above message,
is not set on this kernel.
The keenetic-sdk was cloned and a new firmware was built, according to instructions.
The new firmware ( same version ) works flawlessly.
A kernel parameter CONFIG_NETLINK_DIAG was set via "make kernel_menuconfig" .
The modified firmware was built, but the router does not accept it - says it is for a different model in a nice red banner.
The 4.0 beta 3 was tested - probably CONFIG_NETLINK_DIAG was not set in this version too.
Can you include CONFIG_NETLINK_DIAG=y in the future, please ?
Thank you !
Wireguard interface IPv6 endpoint support
in Feature Requests
Posted
Support of wireguard over ipv6 , please!