alexse

Provider gives IPv6 config with the following parameters: IPv6 address 2a01:XXXX:XXXX::3 IPv6 prefix 2a01:XXXX:XXXX:3::/64 IPv6 gateway 2a01:XXXX:XXXX::1 i configured this as shown. Now My home clients get addresses from 2a01:XXXX:XXXX:3::/64 and i can ping router address 2a01:XXXX:XXXX::3. But the Gateway address 2a01:XXXX:XXXX::1 is not accessible. So is the ipv6 Internet. ip -6 nei show dev eth3 shows gateway as REACHABLE, but no icmp6 echo replies are received from it. What i see - there are different MAC addresses of IPv4 and IPv6 gateways. But it looks normal. For the Keenetic giga kn-1012 shouldn't there be any specific policy to allow IPv6 at least run between router and gateway? I'm fighting with provider for almost a month. Router has Entware installed and running. So i can check the interfaces, MACs, neighbors. Provider recommends connecting my laptop directly to check, but what the heck for? Router is working fine.

How can i enable access to my IPv6 host(s) inside the home network? I have IPv6 enabled and /64 prefix for my home LAN. Now i need to enable external access to the particular address (or group) in my LAN. Is it possible to configure this? I could not find anything about that. Very confusing. Keenetic Giga KN-1012 OS version 4.3.<something i don't remeber>