On the repeaters, the 1st port appears as "down" in all of them.
Devices cannot receive ip. With the "interface up" command, the port did not start to work. The iseg role has been removed.
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
KYTECHNGAMING
Hello,
I noticed something during 3.8.1 though I'm not sure about 3.8.0.
I have a mesh system with 4 Keenetic.
As 1 master controller, 2 repeaters and 1 access point.
In the segment settings, port 1 is set to belong to segments.
https://prnt.sc/TDWrR1zWHyAI
On the repeaters, the 1st port appears as "down" in all of them.
Devices cannot receive ip. With the "interface up" command, the port did not start to work. The iseg role has been removed.
SpeedSter extender https://prnt.sc/2KTJL4SBruP4
MiBox was plugged in my 1st port. When I switch to the 2nd port, it continues to work properly.
I remember it wasn't like this before.
Is it a new feature? Could you give information?
Ticket #588533
Edited by KYTECHNGAMING0 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.