I'm trying to setup an IPv6 address as my DoT resolver, as I read it should be now supported by version 3.9.
I can't do it in the web GUI (the IPv6 address is not accepted), and in the CLI I can add it with "dns-proxy tls upstream <IP address>" but then it doesn't seem to work (web sites will just timeout).
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
fl4co
I'm trying to setup an IPv6 address as my DoT resolver, as I read it should be now supported by version 3.9.
I can't do it in the web GUI (the IPv6 address is not accepted), and in the CLI I can add it with "dns-proxy tls upstream <IP address>" but then it doesn't seem to work (web sites will just timeout).
I'm using a Skipper.
0 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.