bilinmiyor Posted November 30, 2022 Share Posted November 30, 2022 Hello all, I have Keenetic Ultra router and Keenetic Omni DSL modem. Configured Ultra with 2 ISPs named TNT and KNT on Home Segment. TNT (ipv6 /64 prefix) via Omni DSL and KNT (no ipv6) via a cable modem. Both ipv6 are active. Omni DSL gets ipv6 prefix and other ips from ISP and even if I connect my client directly to DSL modem it gets auto ip from its DHCP. However, all my network clients set in Ultra router. But no one is getting ipv6. Omni DSL ipv6 routing list: ::/0 fe80::be4a:xxxx:xxxx:680 TURKNET (PPPoE) 2a02:xxxx:xxxx:3aae::/64 :: Home segment Ultra ipv6 routing list: ::/0 fe80::xxxx:xxxx:fe6c:6e15 TNT Do I need to change anything via CLI? Quote Link to comment Share on other sites More sharing options...
0 bilinmiyor Posted November 30, 2022 Author Share Posted November 30, 2022 I think I figured out the problem. Because of /64 prefix, my router gets 2a02 ipv6 but cannot distribute other clients. My router (Ultra) needs to get ipv6 prefix. So my Omni DSL modem needs an ipv6 dhcp relay within RA relay. Is there any cli command for ipv6 dhcp relay? Quote Link to comment Share on other sites More sharing options...
Question
bilinmiyor
Hello all,
I have Keenetic Ultra router and Keenetic Omni DSL modem.
Configured Ultra with 2 ISPs named TNT and KNT on Home Segment.
TNT (ipv6 /64 prefix) via Omni DSL and KNT (no ipv6) via a cable modem. Both ipv6 are active.
Omni DSL gets ipv6 prefix and other ips from ISP and even if I connect my client directly to DSL modem it gets auto ip from its DHCP.
However, all my network clients set in Ultra router. But no one is getting ipv6.
Omni DSL ipv6 routing list:
Ultra ipv6 routing list:
Do I need to change anything via CLI?
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.