Guest Wifi

[DJFrens]

Hello 

 

i'm trying to setup a guest wifi on my sprinter kn-3710 it does work on the main router but not on the second one in extender mode.

any idea what i'm doing wrong did follow the online instruction

kind regards

 

Edited January 10 by DJFrens

[Le ecureuil]

Do you have your extender acquired in the MWS or did you configured it manually?

[DJFrens]

hello 

used the aquire option in the interface of the main router, it looks like the clients dont get a ip from the ones in extender mode.

[markushka]

Is the connection via a cable? If so, make sure the Guest LAN is also shared on that port.

[DJFrens]

11 hours ago, markushka said:

Is the connection via a cable? If so, make sure the Guest LAN is also shared on that port.

it does get a ip now on the extender, but no internet connection

[markushka]

If it is connected with a cable, ensure the port is the WAN port on the sprinter, and on your main router, in Guest Segment, ensure under Ports and VLAN Settings, that T is on the port where the extender cable is attached. Show other segments should have a tick for Home Segment on the same port.

Under IP Settings, make sure Use NAT is enabled and the Internet Traffic Handling Rules "Connection Policy" has your provider ISP connection selected.

If the Guest Wifi works on the main router, personally, I would remove the extender from the mesh, factory reset and rejoin. Then you will know if it is a config on the main router or the extender.