Can NOT Access Second Remote Subnet on IPSec VPN

[Mr.Oz]

Hi,

I'm using "Hopper DSL (KN-3610) TR" modem. Installed KeeneticOS version 4.3.4.

I defined a site-to-site connection on this modem and defined two remote subnets on this connection.

After the connection is activated, I can connect to the address at the top of the subnet definition (10.90.88.197) but can NOT connect to the address at the bottom (192.168.80.121).

When I change the subnet positions as below, connect to 192.168.80.121 succeeds, while connection to 10.90.88.197 fails.

When I inquired about the situation with the remote party, they told me that the request to the second subnet address was not received in both cases.

I kindly request your assistance on this case.

Have a nice day

Edited July 10 by Mr.Oz

[Mr.Oz]

Hi again,

So far I haven't figured out how to solve this issue.

Does anyone know how to bypass this problem.. I kindly request your assistance on this case.

Have a nice day

[SySOPik]

try to enter all networks in the format xx.xx.xx.0 /24 for test case

[Mr.Oz]

11 hours ago, SySOPik said:

try to enter all networks in the format xx.xx.xx.0 /24 for test case

 

Thank you for your attention..

I tried to change as you suggested but UI did not let me change it as /24..

[Mr.Oz]

Modem software does not support two remote addresses in one definition.. and the modem UI does not support entering 2 connections with same gateway.. 

I have downloaded the config and updated it with 2 connections with same gateway and now it is working..

[SySOPik]

192.168.1.0/24, 192.168.80.0/24, 10.90.80.0/24. We  use a subnet and not a single IP address.

9 hours ago, Mr.Oz said:

I have downloaded the config and updated it with 2 connections with same gateway and now it is working..

ok