rAcKShen

Works. Great! Did not set it as ‘answer’, not to confuse the linearity of posts. Hope you do not mind.

I went for the command-line interface (via the Web interface). However, I guess, one example is sufficient. Isn’t it, @admin?

{ "release": "3.07.C.4.0-2", "sandbox": "stable", "title": "3.7.4", "arch": "mips", "ndm": { "exact": "…", "cdate": "29 Mar 2022" }, "bsp": { "exact": "…", "cdate": "30 Mar 2022" }, "ndw": { "version": "3.7.74", "features": "wifi_button,single_usb_port,led_control,wifi5ghz,mimo5ghz,atf5ghz,dual_image,wifi_ft,wpa3", "components": "base,cloudcontrol,corewireless,ddns,dhcpd,dlna,dns-https,dns-tls,dot1x,easyconfig,exfat,ext,fat,hfsplus,igmp,ip6,l2tp,lang-de,lang-en,miniupnpd,mws,nathelper-ftp,nathelper-h323,nathelper-pptp,nathelper-rtsp,nathelper-sip,ndns,ntfs,nvox,pingcheck,ppe,pppoe,pptp,storage,trafficcontrol,tsmb,usb" }, "ndw3": { "version": "1.30" }, "manufacturer": "Keenetic Ltd.", "vendor": "Keenetic", "series": "KN", "model": "Carrier (KN-1711)", "hw_version": "11178000", "hw_type": "router", "hw_id": "KN-1711", "device": "Carrier", "region": "EU", "description": "Keenetic Carrier (KN-1711)", "prompt": "(config)" } Very much vanilla, except IPv6 and Phone, I think. By the way, a reset via the Web interface (or a change to the Extender mode) does not reset the components. Is there any trick to reset the components, except going for a Recovery?

No. Yes, they depend. I had to remove WebDAV first to be able to remove KeenDNS. On the (Web) interface everything looks fine, I commit the change, my Keenetic is doing something, restarts. Everything looks fine. But then I list the components and KeenDNS is there again. In Wireshark, I see its traffic. So it is active as well.

I try to follow these steps to remove the KeenDNS component (4). Works. However, after the device restarted, that component is installed again (and running). Any idea how I could debug this further, in which log I should look into? Tried both with 3.7.4 (3.07.C.4) and 3.8 Alpha 8 (3.08.A.8). Reset via Web interface.

I am using my Keenetic not as Router but as Extender, without any controller, as simple Wi-Fi access point. However, in Wireshark, I see a lot of LLDP Broadcasts on the LAN interface. Yes, my switch could (and does) filter that. Anyway, is there is command to disable those LLDP broadcasts?