Jump to content
  • 2

Ошибка при смене уровня мощности. execute blocked in MWS member mode [coala/rci].


Mamay
 Share

Question

При попытке сменить уровень мощности wifi в mesh, на ретрансляторе по воздуху 1111. Сохранить новое значение не получается. 

 

Янв 13 19:15:48

 ndm

Core::Configurator: interface country-code: execute blocked in MWS member mode [coala/rci].

Янв 13 19:15:48

ndm

Network::Interface::Rtx::WifiMaster: "WifiMaster0": PHY mode set.

Янв 13 19:15:48

ndm

Network::Interface::Rtx::WifiMaster: "WifiMaster0": auto channel mode set.

Янв 13 19:15:48

ndm

Network::Interface::Rtx::WifiMaster: "WifiMaster0": scheduled auto rescan, interval 6 hours.

Янв 13 19:15:48

ndm

Network::Interface::Rtx::WifiMaster: "WifiMaster0": channel bandwidth setting applied.

Янв 13 19:15:49

ndm

Network::Interface::Rtx::WifiMaster: "WifiMaster0": TX power level set.

Янв 13 19:15:49

ndm

Network::Interface::Rtx::WifiMaster: "WifiMaster0": TX burst enabled.

  • Thanks 1
Link to comment
Share on other sites

5 answers to this question

Recommended Posts

  • 0

Та же проблема kn 1011 в mesh 2 штуки , прошивка 3.7.1 .  Там не только мощность , а изменения любого параметра выдает такую ошибку 

Android 11

Edited by German Ко
  • Thanks 1
  • Upvote 1
Link to comment
Share on other sites

  • 0
6 часов назад, MDP сказал:

Только значения всё же сохраняются. 

+Перепроверил. Когда писал багрепорт, не увидел, что таки применилось!

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Answer this question...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...